I am interested in the RangeRite product for vibration monitoring of heavy equipment But I would like to get better resolution than 18 bit. The precision logger has plenty of resolution but th...

Great question! We tested with the "ESP32 Dev Module" and the "ESP32S3 Dev Module." But the fast GPIO changes should work on any ESP32 that supports the libraries below. You can also grab the examp...

Older USB 2.0 connectors may only support up to 500mA max output current. But newer USB A connectors and USB C based connectors can handle 1.5A or more. Keep in mind that these currents are dictate...

Great question, The DAC IC family used on the Quadra DAC (AD5686/5/4) starts with the internal reference on by default, but by changing Internal Reference Setup Register (DB0) you can turn off the ...

Thanks for the product input, it is much appreciated. We actually do have that on our roadmap (+/- 5V and +/- 10V) with a lot of other product ideas we are excited about. But because the roadmap is...

Thanks for the question. Currently all our DAC and ADC products use a SPI interface to handle digital data. Because SPI is a serial interface and just like any communication protocol it comes with ...

Thanks for the question! The easiest way is to route one of the current source outputs either, IDAC1 or IDAC2, to the VIN+ connector and tie VIN- to ground. From there connect the Vin+ and Vin- acc...

For the precision multimeter reference design, the product page mentions that the built-in current source along with Vin+ and Vin- inputs can be used to make resistance measurements. Is there ...

Browsing through the products looks like the fastest Anabit DAC that can do 5V out is 2MSPS, do you have any DAC products that have faster sample rates? I am looking for something that can do aroun...

Can you feed in an external voltage reference to the Quadra DAC product? If yes, would the gain control still work? With the op amp buffered outputs, can the Quadra DAC go down to true zero?

For the SymmPower product with the USB C connector, can most USB ports handle the max current draw of 550mA? Also any thermo issues that I need to look out for if running it at max power? Does it n...

I like the concept of the VoltHive product, but need higher voltages with bipolar outputs. Do you have any plans to release something similar that can support +10V and -10V with similar s...

I noticed in the Arduino example code for the Flex ADC product that ESP32 based arduinos can get faster sample rates of the ADC due to their faster chip select function calls. What ESP32 Ardui...